B15 - Cycle Computer

B15 Bicycle Computer

Supplemental instructions for Bicycle Computer, please read all instructions (complete instructions are inside the package) before beginning.

1. Attach the sensor to the front left fork blade, near the center of the wheel, by sliding the strap around the fork, and through the slot on the sensor body. Use the rubber shims (found in the round mounting shoe) to make a tight fit if necessary.

2. Unscrew the magnet unit. Slide the magnet halves around a spoke on the wheel, and align the magnet with the sensor, leaving 1mm clearance between the two.

3. Route the wire from the sensor up the fork, using the included zip ties to secure it at the top & bottom of the fork. Tape it down if necessary: the wire must not hang loosely. From the top of the fork, leave enough slack to allow free movement of the front wheel, and next route the wire up & around the brake cable and finally to the handlebars. Extra wire should be carefully wound around the stem. Last, secure it with a zip tie.

4. The mounting shoe goes on your handlebars with the attached screw & rubber shim if needed. Make sure it is mounted so the computer will face you when you are seated on the bike (the screw will be toward you).

5. Insert the battery into the computer with the printed side facing up. Within 15 seconds of battery insertion, use the left button to choose km/h or m/h. Next, press the right button to switch to Wheel Size, and use the left button again to select the correct size. The default is 208 (a chart is included with the package instructions). Hold in the button cycle through the upper limit and start again from the smallest unit.

For all other settings, see package instructions. The Right button cycles through modes, and Left button sets any individual setting within a mode. The modes are explained in complete detail in the package instructions below.

PAGE 1

PAGE 2 (continues from the section Auto Start/Stop)

Return to Product Support Page