D13 - Pore Cleaner

To Insert Battery:
Push down with your thumb to slide the On/Off switch cover downward and off. Inside the cover is a picture to show how to align the battery: the positive side should be up toward the head of the Cleaner, the negative side should be at the bottom of the device.
Replace the cover.

Using the Pore Cleaner:

To prevent bruising, follow these guidelines:
Around the nose: under one minute
Forehead & Jaw: within two minutes
If you have sensitive skin, do not move the Cleaner over the same area more than three times.

Don't tug on the Pore Cleaner while using or try to pull it straight off, it will be difficult.
Do not use the Pore Cleaner while there is any soap, cleanser, or other facial product on your skin. Simply warm your face slightly with warm water, and move the Pore Cleaner over your face as described below:

Around the nose:
Use the round, oval cup side of the Cleaner. Remember to keep cleaning time under one minute.
Begin behind your nostril and move it up over the nostril, out to the tip of your nose. Then move downward from the middle and sides of your nose to the tip.
(Picture is included with product instructions.)
Forehead and Chin area:
Use the flat, more rectangular side of the Cleaner. Keep the cleaning time to a total of two minutes.
Begin cleaning from the center of your forehead out to the temples, first one side, then the other. Do the same on your chin, move outward from the center on each side of your face.

Next, wash your face as usual.

Cleaning the Pore Cleaner:

Use a basin of warm water only (no hotter than 70°C or 158°F), no soap. Remove the cup and hold the cleaning head in the water to operate for 15 seconds. Do not immerse the entire product! After the 15 seconds in the water, take it out and keep it operating for 30 seconds to remove the water from the inside. Wash the cup separately. Dry the Cleaner and the cup thoroughly with tissue, and replace the cup.
Any dirt remaining on the filter net of the Cleaner head can be removed with a soft toothbrush.

Return to Product Support Page